User Guide

2
User Mode
2-18 PageScope Light
Orientation: Specify the image orientation that will be used if
the controller receives a print job where the
image orientation is not specified.
Output: Specify the print method that will be used if the
controller receives a print job where double-
sided printing is not specified.
(If the duplex unit is installed: “Single Sided”, “2-
Sided (Left Binding)” or “2-Sided (Top Binding)”
If the duplex unit is not installed: “Single Sided”)
Copies: Specify the number of copies that will be printed
if the controller receives a print job where the
number of copies is not specified.
Reprint (Proof&Print)
• Hold After Re-
print:
Select whether or not the print data is saved after
reprinting is finished.
•Re-print Hold
Time:
Specify the length of time that the reprint data is
saved.
Document Hold
Time:
Specify how much time should be allowed to
pass before print data is cleared when memory
capacity is exceeded while print data is being
spooled.
[Apply] button: Click this button to change the settings to the
new ones that were specified or selected.
[Clear] button: Click this button to clear the new settings that
were specified or selected.