User Guide

Administrator Mode
3
PageScope Light 3-53
✎
Note
After changing the settings for parameters marked with an asterisk (*),
turn the copier off, then on again.
• Host Name: Type in the host name for the POP3 server.
(64 alphanumeric characters or less)
*This parameter appears if “DNS Settings” is set
to “Yes” on the page that appears after clicking
“TCP/IP” in the sub-menu that appeared after
clicking “Common Setting” in the menu on the
[Network] tab after logging into the Administrator
mode.
POP3 User Name: Type in the login name for the POP3 server.
(64 alphanumeric characters or less)
POP3 Password: Type in the password for logging into the POP3
server.
(32 alphanumeric characters or less)
Auto-RX Check: Select whether or not to automatically check for
received e-mails.
Auto-RX Check
Interval:
Specify the time interval for automatically
checking for received e-mails.
Port Number: Type in the port number of the POP3 server.
POP3 Timeout*: Specify the amount of time until transmissions to
the POP3 server time out.
[Apply] button: Click this button to change the settings to the
new ones that were specified or selected.
[Clear] button: Click this button to clear the new settings that
were specified or selected.