User Guide

Administrator Mode
3
PageScope Light 3-43
✎
Note
After changing the settings for parameters marked with an asterisk (*),
turn the copier off, then on again.
Subnet Mask*: Type in the subnet mask of the connected
network.
*Type in the subnet mask only if “DHCP Settings”
is set to [Disable].
Gateway Address*: Type in the default gateway address of the
connected network.
*Type in the default gateway address only if
“DHCP Settings” is set to [Disable].
RAW Port Number: Type in the port number for RAW printing.
Self-domain
Name*:
<Available only if the internet fax & network scan
kit is installed>
Type in the domain name for the controller.
(64 alphanumeric characters or less)
DNS
Configuration:
Specify whether or not the DNS (Domain Name
System) function is used.
Host Name: Type in the DNS host name.
(64 alphanumeric characters or less)
*Type in the host name only if “DNS Settings” is
set to [Yes].
Domain Name: Type in the DNS domain name.
(64 alphanumeric characters or less)
*Type in the domain name only if “DNS Settings”
is set to [Yes].
DNS Server
Address1 through
3:
Type in the IP address of the DNS server.
*Type in the DNS server address only if “DNS
Settings” is set to [Yes].
DNS Query
Timeout:
Specify the amount of time until inquiries to the
DNS server time out.
*Specify the timeout period only if “DNS Settings”
is set to [Yes].
[Apply] button: Click this button to change the settings to the
new ones that were specified or selected.
[Clear] button: Click this button to clear the new settings that
were specified or selected.