User Guide

4
4.4 Making Copies Using Accounts
4-6 Di2510/Di3010/Di3510
Basic Copy Operations Chapter 4
4.4 Making Copies Using Accounts
Using the “Copy Track Mode” Parameter
The number of copies allowed for each registered account can be restricted.
The accounts can be managed by touching [Account management] on the Admin.
1 screen (displayed by touching [Admin. Management] on the Utility screen). The
Administrator Management settings should be specified by the administrator.
✎
Note
The Administrator Management parameters cannot be set by anyone without
knowledge of the administrator access code.
For details on the administrator access code, contact your service representa-
tive.
To make copies when accounts are specified
When managing using [100 Account 1] and [100 Account 2].
1 The screen shown at the right
appears if the Printer Controller,
Network Interface Card and
Network Scan Kit (or Internet Fax
& Network Scan Kit) is installed.
Select the desired account.
If [100 Account 2] has been
selected, pressing the [Access]
key will display the screen shown
at the right.
❍ To search for an account
number, touch [No.], and then
type in the desired account
number.
❍ The screen shown at the right
appears if the Printer
Controller, Network Interface
Card and Network Scan Kit (or
Internet Fax & Network Scan
Kit) is not installed.
If [100 Account 2] has been
selected, pressing the [Access] key will display the screen shown at the
right.
2 Using the 10-Key Pad, enter the 6-digit access code for the desired account.