User's Manual
Table Of Contents
- About Trademark
- Important Safety Instructions
- Chapter 1 Overview
- Chapter 2 Preparation
- 2.1 Unpacking & Checking
- 2.2 Removing the Protective Materials
- 2.3 Parts Identification
- 2.4 Installing the Printer
- 2.5 Installing and Removing the Paper rack
- 2.6 Installing the Ribbon Cartridge
- 2.7 Connecting the Printer to Your Computer
- 2.8 Connecting to the Power Cord
- 2.9 Installing Driver
- 2.10 Ethernet Settings
- Chapter 3 Loading Paper
- Chapter 4 Control Panel
- Appendix A Printer Maintenance
- Appendix B Specification
Documax 5380 User’s Manual
- 15 -
2.10.3 Installing Printer Network Driver
The ways of installing network driver are classified into Newly-install way and Upgrade-install way
according to whether the PC installs the printer driver or not.
If the printer driver hasn’t been installed on the PC, adopt newly-install way whose steps are shown in
“Newly-install printer network driver”.
If the printer driver has been installed on the PC, adopt Upgrade-install way whose steps are shown in
“Upgrade-install printer network driver”.
1. Newly-install printer network driver
1) Click “Start” → “Settings” → “Select Printers”.
2) Click “Add printer”, then a window of “Add Printer Wizard” pops up, click “next”, then please read
the select guide carefully. Such as, select “Local or Network Printer”, then click “next”.
3) A window of “Select the Printer port” pops up, select a port you want your printer to use. For
example, select “Create a new port”, select “Standard TCP/IP Port” in the port, click “next”.
4) A window of “Add standard TCP/IP Printer Port Wizard”, click “Next”.
5) A window of “Add Port” pops up, enter the IP address reported by the “Setting printer’s IP
address” in the “Printer Name or IP Address” column. Take IP address “192.168.0.240” for
example. “Port Name” is created automatically after finishing filling in IP address.