User's Manual
Table Of Contents
- About Trademark
- Important Safety Instructions
- Chapter 1 Overview
- Chapter 2 Preparation
- 2.1 Unpacking & Checking
- 2.2 Removing the Protective Materials
- 2.3 Parts Identification
- 2.4 Installing the Printer
- 2.5 Installing and Removing the Paper rack
- 2.6 Installing the Ribbon Cartridge
- 2.7 Connecting the Printer to Your Computer
- 2.8 Connecting to the Power Cord
- 2.9 Installing Driver
- 2.10 Ethernet Settings
- Chapter 3 Loading Paper
- Chapter 4 Control Panel
- Appendix A Printer Maintenance
- Appendix B Specification
Documax 5380 User’s Manual
- 9 -
2.8 Connecting to the Power Cord
1. As Figure 2-14 shown, make sure the printer is turned off. (The pressed down side of the power
switch with “O” marks denotes the printer is off.)
2. Make sure the voltage required by the printer matches that of your electrical outlet.
3. Plug one end of the power cord into the printer’s power supply inlet.
4. Plug the other end of the power cord into a properly grounded electrical outlet.
To turn the printer ON, press the I mark at the side of the power switch.
To turn the printer OFF, press the O mark at the side of the power switch.
Caution: 1. If the rated voltage doesn’t match the outlet voltage, contact your dealer for
assistance. Do not plug in the power cord.
2. Use the electrical outlet connecting the ground properly.
2.9 Installing Driver
Please use the cable to connect computer with printer, then turn on the computer and the printer, put
the driver CD into the CD-ROM. Install driver by the following way:
Auto-installing way
Double click the file "Setup.exe" in the driver disc, install driver by the following direction.
Note: Auto-installing way just work in operating system of Windows2000 or above.
Figure 2-14 Connecting the power cord to the printer
Figure 2-13 Connecting to the serial interface
Serial interface
Serial cable
Screw
Power cord
Power switch
Power supply inlet
Electrical outlet