User's Manual
Table Of Contents
- Declare
- Important Safety Instructions
- Chapter 1 Function Chracteristic
- Chapter 2 Preparation
- 2.1 Unpacking & Checking
- 2.2 Dismantling Protective Materials
- 2.3 Parts Identification
- 2.4 Installing the Printer
- 2.5 Installing the Ribbon Cartridge
- 2.6 Installing and Dismantling the Right and Left Holders
- 2.7 Installing and Dismantling the Front Table
- 2.8 Installing the Tractor
- 2.9 Connecting to the Printer
- 2.10 Connecting to the Power Source
- 2.11 Installing Driver
- 2.12 Network Settings
- Chapter 3 Control Panel
- Chapter 4 Printer Setting
- Chapter 5 Menu Function Description
- 5.1 Emulation
- 5.2 Print Mode
- 5.3 Font Select
- 5.4 Compress Printing
- 5.5 Characters Pitch
- 5.6 Chinese Pitch
- 5.7 Line Feed Pitch
- 5.8 Top of Form Adjustment
- 5.9 Page Length Tractor
- 5.10 Page Length Manual
- 5.11 Page Width Detect Right
- 5.12 Page Width Detect Left
- 5.13 Top Margin
- 5.14 Bottom Margin
- 5.15 Left Margin
- 5.16 Text Direction
- 5.17 Graph Direction
- 5.18 Zero Style
- 5.19 Character Table EPSON
- 5.20 Character Table IBM
- 5.21 International Font
- 5.22 Code Page
- 5.23 AGM Mode
- 5.24 Paper Skew Detection
- 5.25 Jam Detection
- 5.26 Manual Eject the Paper
- 5.27 Language
- 5.28 Quiet Mode
- 5.29 Carriage Return Setting
- 5.30 Line Feed Setting
- 5.31 Tear off Function
- 5.32 Load Paper
- 5.33 Cover Detection
- 5.34 Baud Rate
- 5.35 Parity Bit
- 5.36 Data Length
- 5.37 Stop Bit
- 5.38 Protocol
- Chapter 6 Troubleshooting
- Chapter 7 Printer Specification
- Appendix A Self-test and Adjustment
ACCEL-7450 User's Manual
- 42 -
5.35 Parity Bit
Set the printer serial interface parity checking type. It includes NONE, ODD and EVEN.
Setting process:
MENU SETUP PARITY BIT
35. PARITY BIT ► 1. NONE ※
36. DATA LENGTH ► 2. ODD
3. EVEN
5.36 Data Length
Select the serial interface data length.
Setting process:
MENU SETUP DATA LENGTH
36. DATA LENGTH ► 1. 8 BITS ※
37. STOP BIT ► 2. 7 BITS
5.37 Stop Bit
Select the serial interface data transport stop bit.
Setting process:
MENU SETUP STOP BIT
37. STOP BIT ► 1. 1 BIT ※
38. PROTOCOL ► 2. 2 BITS
5.38 Protocol
Set the printer’s serial interface as software control (XON/XOFF) or hardware control (DTR).
Setting process:
MENU SETUP PROTOCOL
37. STOP BIT ► 1. XON/XOFF
38. PROTOCOL ► 2. DTR ※