User's Manual
Table Of Contents
- Declare
- Important Safety Instructions
- Chapter 1 Function Chracteristic
- Chapter 2 Preparation
- 2.1 Unpacking & Checking
- 2.2 Dismantling Protective Materials
- 2.3 Parts Identification
- 2.4 Installing the Printer
- 2.5 Installing the Ribbon Cartridge
- 2.6 Installing and Dismantling the Right and Left Holders
- 2.7 Installing and Dismantling the Front Table
- 2.8 Installing the Tractor
- 2.9 Connecting to the Printer
- 2.10 Connecting to the Power Source
- 2.11 Installing Driver
- 2.12 Network Settings
- Chapter 3 Control Panel
- Chapter 4 Printer Setting
- Chapter 5 Menu Function Description
- 5.1 Emulation
- 5.2 Print Mode
- 5.3 Font Select
- 5.4 Compress Printing
- 5.5 Characters Pitch
- 5.6 Chinese Pitch
- 5.7 Line Feed Pitch
- 5.8 Top of Form Adjustment
- 5.9 Page Length Tractor
- 5.10 Page Length Manual
- 5.11 Page Width Detect Right
- 5.12 Page Width Detect Left
- 5.13 Top Margin
- 5.14 Bottom Margin
- 5.15 Left Margin
- 5.16 Text Direction
- 5.17 Graph Direction
- 5.18 Zero Style
- 5.19 Character Table EPSON
- 5.20 Character Table IBM
- 5.21 International Font
- 5.22 Code Page
- 5.23 AGM Mode
- 5.24 Paper Skew Detection
- 5.25 Jam Detection
- 5.26 Manual Eject the Paper
- 5.27 Language
- 5.28 Quiet Mode
- 5.29 Carriage Return Setting
- 5.30 Line Feed Setting
- 5.31 Tear off Function
- 5.32 Load Paper
- 5.33 Cover Detection
- 5.34 Baud Rate
- 5.35 Parity Bit
- 5.36 Data Length
- 5.37 Stop Bit
- 5.38 Protocol
- Chapter 6 Troubleshooting
- Chapter 7 Printer Specification
- Appendix A Self-test and Adjustment
ACCEL-7450 User's Manual
- 8 -
2.9.2 Connecting to the USB Interface
1. Plug the USB cable A end (flat shape) into the computer's USB interface. As shown in Figure 2-13.
2. Plug the USB cable B end (square shape) into the printer's USB interface.
Note: Don't impact the plug after connecting to the USB cable.
2.9.3 Connecting to the Ethernet Interface
Plug the RJ-45 crystal plug of the Ethernet cable into the printer, and plug the other plug into the LAN.
As shown in Figure 2-16.
Note: The details of Ethernet interface printer’s net setting please refer to the User’s Manual.
2.9.4 Connecting to the Serial Interface
1. Turn off both the computer and the printer. Plug the serial cable connector securely into the
printer's serial interface. Then tighten the screws on both sides of the connector. As shown in
Figure 2-17 or Figure 2-18.
2. Plug the other end of the cable into the computer's serial interface; then tighten the screws on both
sides of the connector, and make sure it is tight to the interface.
Figure 2-15 Connect to the USB interface
Figure 2-16 Connect to Ethernet interface
Figure 2-17 Connect to the serial interface (9-pin)
USB cable
USB interface
Ethernet cable
Ethernet interface
Serial interface
Serial cable
Screw