User's Manual
Table Of Contents
- Declare
- Important Safety Instructions
- Chapter 1 Function Chracteristic
- Chapter 2 Preparation
- 2.1 Unpacking & Checking
- 2.2 Dismantling Protective Materials
- 2.3 Parts Identification
- 2.4 Installing the Printer
- 2.5 Installing the Ribbon Cartridge
- 2.6 Installing and Dismantling the Right and Left Holders
- 2.7 Installing and Dismantling the Front Table
- 2.8 Installing the Tractor
- 2.9 Connecting to the Printer
- 2.10 Connecting to the Power Source
- 2.11 Installing Driver
- 2.12 Network Settings
- Chapter 3 Control Panel
- Chapter 4 Printer Setting
- Chapter 5 Menu Function Description
- 5.1 Emulation
- 5.2 Print Mode
- 5.3 Font Select
- 5.4 Compress Printing
- 5.5 Characters Pitch
- 5.6 Chinese Pitch
- 5.7 Line Feed Pitch
- 5.8 Top of Form Adjustment
- 5.9 Page Length Tractor
- 5.10 Page Length Manual
- 5.11 Page Width Detect Right
- 5.12 Page Width Detect Left
- 5.13 Top Margin
- 5.14 Bottom Margin
- 5.15 Left Margin
- 5.16 Text Direction
- 5.17 Graph Direction
- 5.18 Zero Style
- 5.19 Character Table EPSON
- 5.20 Character Table IBM
- 5.21 International Font
- 5.22 Code Page
- 5.23 AGM Mode
- 5.24 Paper Skew Detection
- 5.25 Jam Detection
- 5.26 Manual Eject the Paper
- 5.27 Language
- 5.28 Quiet Mode
- 5.29 Carriage Return Setting
- 5.30 Line Feed Setting
- 5.31 Tear off Function
- 5.32 Load Paper
- 5.33 Cover Detection
- 5.34 Baud Rate
- 5.35 Parity Bit
- 5.36 Data Length
- 5.37 Stop Bit
- 5.38 Protocol
- Chapter 6 Troubleshooting
- Chapter 7 Printer Specification
- Appendix A Self-test and Adjustment
ACCEL-7450 User's Manual
- 30 -
4. After connect the printer with the computer, and then print out the test page.
Caution: As the paper sensor is near to the left of the paper in position, so the paper should
be fed in along the left side (the “0” position of ruler) could it be detected.
If the paper is skew when feeding paper, the paper skew sensor detects it and puts it right
automatically (The Paper skew function in the Menu should be on).
4.2 Setting up the Tractor Mode
1. Firstly, please ensure the tractor has been installed at the back of the printer, and then adjust the
right and left paper guides on the front table to the proper positions.
2. Adjust the positions of the tractor right and left sprockets to fulfill the requirement of the paper width.
Please lock the tractor after adjustment.
3. Open the sprocket cover, aim the tractor paper holes at the sprockets and install it correctly, and
then close the sprocket cover.
4. Pull the paper select lever to the position of “ ”.
Loosen
Lock
Sprocket cover