User's Manual

Cautions in setting up
 Place the printer on a rigid, horizontal
base in a location that is free of
vibration.
 Before connecting or disconnecting
the interface cable, be sure to turn off
the printer.
 Do not connect the printer to a
non-standard power source.
 Unpack the printer. Make sure that the
printer body and all accessories are included
in the package and no parts are damaged.
 Do not sue the printer in a location exposed
to direct sunlight or close to a heater or other
heat generating equipment.
 Do not use the printer in a dusty location or
any location subject to sudden changes in
temperature and humidity.
Cautions in setting up
 If any foreign matter gets into the printer,
turn off the printer immediately and remove
the foreign matter.
 If the case or cover becomes dirty, clean it
with a soft cloth moistened with a small
quantity of neutral detergent diluted with
water. Never use a hard cloth or volatile
solvent such as alcohol, thinner, or benzine.
 Take care not to twist the ribbon while
installing the ribbon cassette.
 Never try to print without a ribbon
cassette installed and paper loaded.
 Push the lock levers of both tractors to
the LOCK positions firmly while loading
fanfold paper or single sheet paper. It is
for the purpose of setting paper path
securely.
 Do not turn off the printer during
printing, as this may lead to a
 Use two hands and hold firmly at each end
when lifting the cut sheet feeder. Personal
injury can occur if the ASF unit is
dropped.
 Do not put your finger on the tractor gear,
when using the rear tractor.
 Do not touch the print head immediately
after printing because it is too hot.
 Do not put your finger under the tractor
cover while loading fanfold paper.
Safety Cautions