User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 5 Troubleshooting
32
5.2.2 Operational error message
• The print head is being cooled to prevent it fro
m
overheating. The ONLINE lamp blinks.
The print head has become too hot during
high-density printing. When this message is
displayed, the printing speed is reduced o
r
printing stops. When the print head temperature
drops, the printer restarts printing.
• This error message indicates that fanfold paper is
not fed back to the packing position properly.
Cut the paper to remove it.
Fanfold paper is not set on the front tractor.
Install fanfold paper on the front tractor an
d
press the ONLINE key.
Fanfold paper is not set on the rear tractor. Install
fanfold paper on the rear tractor and press the
ONLINE key.
A cut sheet is not loaded into the printer. Put
a
cut sheet on the front rack and load it into the
printer.
A cut sheet is not set into the CSF. Install cu
t
sheets into the CSF and press the ONLINE key.