User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 5 Troubleshooting
30
6. The paper sensor does not detect paper. (The print start position of
paper tilts downward)
The detection capability of the sensors may not be adequate level.
Perform the EEPROM Initialization 2. (See page 5 - 3)
7. Out-of-paper can not be detected.
In case that the printing is continued even when the paper is out, the setting may not be
adequate.
Make sure of the paper size, the page length on MENU and the format of the printing data.
The message "REMOVE PAPER" appears even when the paper is ejected, the detection
capability of the sensors may not be adequate level.
Perform the EEPROM Initialization 2. (See page 5 - 3)
8. Not straight in vertical line printing.
Select “ BIDIRECTIONAL” at the setting of #48 PRINTING DIRECTION.
9. Incorrect characters printed.
The connection with the PC may not be correct.
Check whether the cable connection is faulty or broken.
10. Unexpected printing results.
The gap occurs between the print start position and the top end of paper.
Adjust the gap by setting #3 - #6 TOF ADJUSTMENT in the MENU mode.
(The setting on MENU differs in accordance with each paper path.)
The unexpected printing position occurs right and left.
Adjust the position moving the tractors or the paper guides right and left.
#15 LEFT MARGIN in the MENU mode is effective to adjust the position.
The unexpected printing position occurs from the second page of fanfold paper.
The page length of fanfold paper is not correct.
Set the paper length again using #7 and #8 PAGE LENGTH in the MENU mode.
The setting on the PC also need to be checked.
The unexpected printing position occurs vertically after the Out-of-paper.
Select “ PAGE END” at setting of #37 PAPER OUT DETECTION.
11. Restore all the settings in the MENU mode to the factory default
settings.
• EEPROM Initialization 1
Restore the settings in the MENU mode to the factory default settings.
[Procedure]
Keep the HIGH IMPACT and LF keys depressed and turn on the printer.