User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 2 Control panel operation
25
2.3 Head adjustment lever
This lever is for adjusting the gap between the print head and the paper.
The lever position should be at "AUTO " normally, which adjusts the gap in accordance with the SETUP
MODE. When " AUTO " is selected on the panel, the printer measures the paper thickness and adjusts the
gap between the print head and the paper automatically.
In case that the graduation 1 - 7 is selected, the gap between print head and paper is fixed.
Best position can be selected manually to meet the paper thickness as follows;
Graduation 1 for 1 sheet form.
Graduation 7 for 7 sheets multipart form.
2.4 Key shortcut functions
Key shortcut functions are executed by pressing and holding the corresponding keys while simultaneously
turning on the printer power. The following table shows the available shortcut functions.
ONLINE
TEAR OFF
SPEED
EJECT/LPAD
HIGH IMPACT
LF/FF
ENTER
RLF
POWER
Self Test Draft
○
●
Self Test LQ
○
○
●
Hex Dump Draft
○
●
EEPROM INITIAL 1
○ ○
●
EEPROM INITIAL 2
○ ○
●
7
1
AUTO