User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 2 Control panel operation
24
2.2 Paper path lever
The lever for changing the paper path.
Position Paper path
Note
Manual
Rear tractor
ASF
The required paper path can be selected by the setting of the lever.
The paper path command is valid when selecting the “AUTO”.
The lever position should be at “AUTO” when using the printer driver.
Before changing the paper path, remove the paper inside the printer by pressing the EJECT/LOAD key.