User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 2 Control panel operation
22
9. EJECT/LOAD
● If the EJECT/LOAD key is pressed when fanfold paper is loaded, the
paper is fed back to the parking position. When it is pressed when a cut
sheet paper is loaded, the paper is ejected.
● When the EJECT/LOAD key is pressed when fanfold paper is at the
parking position, the paper is loaded to the TOF position.
● When the EJECT/LOAD key is pressed with no paper in the manual
mode, the key is ignored. When it is pressed with paper loaded in the
manual mode, the printer ejects the paper.
● When the EJECT/LOAD key is pressed with no paper in the CSF mode,
the printer loads paper. When it is pressed with paper loaded in the CSF
mode, the printer ejects the paper.
10. LF
Press the LF/FF key to feed the line in the forward direction at a pitch of 1/6
inch.
11. MICRO LF (ALT + LF keys)
Press the MICRO LF key to feed the line in the forward direction at a pitch
of 1/360 inch.
Use this key to adjust the paper position.
13. MICRO RLF (ALT + RLF keys)
Press the MICRO RLF key to feed the line in the reverse direction at a
pitch of 1/360 inch.
Use this key to adjust the paper position.
12. RLF
Press the RLF key to feed the line in the reverse direction at a pitch of
1/6 inch.
Keep the key depressed for continuous reverse line feeding.