User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 2 Control panel operation
21
When using the front tractor along with the CSF, cut the fanfold paper by hand,
not by the paper cutter.
7. ALT
The following functions are executed by pressing the corresponding key
while you press the ALT key.
TEAR OFF→ FF
LF/FF → MICRO LF
RLF → MICRO RLF
HIGH IMPACT → MENU
SPEED → RESET
8. TEAR OFF
Press the TEAR OFF key, and the printer automatically feeds the
perforation of the paper to the paper cutter position (for fanfold paper only).
If the perforation is not adjusted to the cutter position, correct the position
with the MICRO LF or MICRO RLF key. The correct position is saved in
memory, and the perforation is fed automatically to the paper cutter position
at next time.