User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 1 Setting up the printer
13
8. Specify the page length.
Check the fanfold paper size marked on the package.
9. Perform the trial printing after connecting the
printer to the computer.
Adjust the tractors to find a correct position in case that the
printing is tilted to right / left.
In case of tilting vertically the printing start position should
be adjusted by “3 TOF ADJUST”.
When using the front tractor along with the
CSF, cut the fanfold paper by hand, not by
the paper cutter.