User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 1 Setting up the printer
10
In case of tilting vertically the printing position should be
adjusted by “5 TOF ADJUST”.
1.7 Setting up the Front tractor mode
1. Attach the paper rack holders (right / left) to the
printer as shown below.
Press the holders until you hear click.
If a paper is inserted on
the skew as the
upper left of the paper is over the
p
aper guide, the printer may not
adjust the skew. In this case, move
the paper guide to the left a little,
then insert the paper at some
distance from the paper guide.
Note
When printing a book, set BOOK at #10 PAGE
LENGH NOTE BOOK.