User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 1 Setting up the printer
8
9. Perform the trial printing after connecting the printer
to the computer.
Adjust the tractors to find a correct position in case that the
printing is tilted to right / left.
In case of tilting vertically the printing start position should be
adjusted by “4 TOF ADJUST”.
1.6 Setting up the Manual mode
1. Attach the paper rack holders (right / left) and the
paper rack.
See the item No. 1-3 on the page 1-5.
2. Adjust the printing position by sliding the paper guide
right or left.
When loading a wide paper, adjust the
right paper guide.