User's Manual
Table Of Contents
- Chapter 1 Setting up the printer
- 1.1 Unpacking the printer
- 1.2 Connecting the printer to the power source
- 1.3 Connecting the printer to the computer
- 1.4 Installing the ribbon cassette
- 1.5 Setting up the Rear tractor mode
- 1.6 Setting up the Manual mode
- 1.7 Setting up the Front tractor mode
- 1.8 Setting up the CSF (option) mode
- 1.9 Installing the printer driver
- Chapter 2 Control panel operation
- Chapter 3 Setup options
- Chapter 4 How to use SETUP Memory
- Chapter 5 Troubleshooting
- Chapter 6 Specifications
Chapter 1 Setting up the printer
7
7. Slide the paper path lever to the symbol
or the position of "AUTO".
The lever position should be at "AUTO" when using the printer
driver.
8.
Specify the page length.
Fanfold paper size marked on package (Example)
Specify the page length referring the number of sprocket holes on
the paper in case that the paper length can not be specified.
No. of holes x 0.5 inch equals to the page length.
The 8 of holes on the above mean that this fanfold is 4 inches in length.