User's Manual

www.konftel.com
Konftel AB, Box 268, SE-901 06 Umeå, Sweden
Tel: [phone] Fax: [phone]
[e-mail]
110248-61-001 Rev 1C
Konftel Remote Control
Specications
RF carrier frequency 433.92 MHz
Dimensions (W x H x L) 54 x 190 x 25 mm
Unit weight (excl. batteries) 90 g
Battery type AAA x 3 pcs
INSTALLING BATTERIES
Three AAA batteries are required for operation.

Remove the battery cover.

Check the polarity of the batteries and the
“+/-” marks inside the battery compartment.

Insert the batteries following the marks.

Push the battery cover back in place.
Battery safety
• Usenewbatteriesoftherecommendedtype
and size only. Risk of explosion if battery is
replaced by an incorrect type.
• Donotmixoldandnewbatteries.
• Tohelpavoidthechanceofchemicalleaks
remove the batteries from the remote if
you do not intend to use the remote for an
extended period of time.
• Disposeofoldbatteriesproperly.Donotburn
or bury them.
PAIRING

Select MENU > SETTINGS > REMOTE
CONTROL on the conference phone.

Press OK to set the conference phone in
pairing mode.

Press the and buttons on the remote
control simultaneously for three seconds.
The red LED on the remote control starts ashing
and a pairing conrmation appears on the confe-
rence phone display.

Press OK on the conference phone to conrm
that you want to pair the units.
FCC statements
1) Caution: Changes or modications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
2) This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
IC statements
This device complies with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie
Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions
suivantes: (1) l’appareil ne doit pas produire de brouil-
lage, et (2) l’utilisateur de l’appareil doit accepter tout
brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.