Installation Guide

Adjusting the Angles

• Dismount the LogiCam camera from the mounting bracket on the

windshield. Make sure that the mounting bracket is not attached, as it

locks the camera into position.

• Use the screwdriver to loosen the three security screws on the round

side of the camera. Do not remove the screws fully.

• Adjust the viewing angle by rotating the body of the LogiCam and lock

the three side screws when finished.

Screws

Power jack

• Mount the camera back onto the windshield.

• Connect the camera to a power source (page 7).

• The camera will turn on automatically.

• To unblock the camera touch screen enter a default PIN number 3333.