Installation Guide

Hardwire to the Vehicle Fusebox
1. Insert the new fuse tap provided in the kit into “slot 1”, and the fuse
from the fuse box into “slot 2” (12v constant or ignition switch). If you
set them with the wrong order, it will not feed power to the hardware
kit.
1
2. Connect the hardwiring cable with the terminal crimp connector from
the add-a-fuse kit. Trim off some of the rubber tubing to expose the
wiring on your hardwiring cable. Then crimp them down together. You
should be able to crimp the fuse kit with a standard needle nose
pliers. We recommend using electrical tape to further secure the wire.
Add a Fuse Kit
New Fuse Tape
Terminal Crimp
Connector
Hardwire Cable
Ground Wire
13