Installation Guide

Hardwire to the Vehicle Fusebox

Step 1: Locate Your Fuse Box

Check the car owner’s manual for the fuse box location. It may vary

depending on the vehicle model. Remove the plastic panel to access the

fuse box. It may open simply by lifting a tab or pulling it with your fingers,

or use a flat tool that can pinch in between the plastics.

Step 2: Which Slot Should I Use?

Use a circuit tester to test which fuse is constant (typically red) and

provides 12v of power. A fuse that is constant will stay active when the

car is off. The camera will automatically enter standby mode when the

car is not moving for 10 minutes.

Step 3: Add-a-Fuse Kit

We recommend using an add-a-fuse kit included in our Essential Install

Package, for a more secure, long lasting installation. The add-a-fuse kit

provides a fuse slot for the existing OEN circuit (12v constant, #2 in

picture below) and another fuse slot for the new circuit for the dash cam

device (#1 in picture below).