Installation Sheet

Canopy Installation
OFF
ON
Your circuit
breaker may
look
different.
Shock Hazard. Electric shock could result in serious injury or death. Make sure circuit
breaker is set to OFF before installaon. Must be installed by a qualified electrician.
1
pendant light
Z-BAR
rise rectangle
rise rectangle rise rectangle
rise rectangle
Aach LED light bars to the joints as illustrated below. Make sure they are fully inserted with no gaps.
The top layer consists of the shorter light bars, while the boom layer consists of the longer bars.
Canopy Installation
2
pendant light
Z-BAR
Use the provided
strings to hang the
cover plate from
the canopy during
installaon
Feed the AC power cords from the
LED drivers into the juncon box
through the hole then connect them
to the live and neutral wires from the
juncon box accordingly. Connect the
ground wire from the canopy to the
juncon box’s ground wire. Make
sure the canopy is centered to and
fully covering the juncon box.
Secure the canopy to the juncon
box using the 2 provided screws.
-
+
-
+
3
Canopy Installation
pendant light
Z-BAR
Cable grippers
are in the bag
labeled “a”.
Pull the core wire out and fit it
into the + posive terminal.
Twist the skin of the wire and
fit it into the - negave terminal.
-
+
N L
Feed the cables through the
assembly as illustrated. Tighten
all cable grippers to their
respecve holders.
All wires should be of equal
length. Wires can be released and
re-adjusted by pressing the
cable grippers’ “nozzle”.
When no more adjustments are needed, remove the hanging strings and secure the cover plate to the canopy by fing the four
small screws in from the sides.
BOTTOM VIEW
Canopy Installation
5
4
pendant light
Z-BAR
Overheang may result in reduced LED lifespan:
• Keep out of direct sunlight.
• Remove plasc bag from lamp before use.
• Recommended ambient temperature: under 77 °F.
Koncept Inc.
429 E. Huntington Drive
Monrovia, CA 91016, USA
Phone: [phone]
Fax: [phone]
[e-mail]
Warning: To reduce the risk of fire, electric shock or injury:
• Do not use in wet locaons
• Do not handle plug or appliance with wet hands
• Do not stare directly at LEDs
www.koncept.com
Specificaons
Register your Koncept LED lamp online and receive:
• One Year Warranty Extension
• Priority Product Servicing
Visit www.koncept.com/productsupport and enter your
serial number (S/N: XXXXXXXX) located on your product.
Model ZBP-RR
Color Temperature 3000 K
Light Color So Warm
Brightness Adjustability
Compable w/ELV or LED dimmers
Input voltage 120V only
Koncept warrants to the original purchaser of this product against manufacturer defects in design, assembly, material, or workmanship, and will, at
Koncept’s opon, replace or repair any defecve product free of charge. This coverage is valid for five years from the date of purchase as long as the
original purchaser owns the product. In the case of a hardwired product, this warranty is valid for one year for the LED driver specifically. Koncept will
replace or repair the product, which Koncept, at its sole discreon, agrees is defecve, free of charge provided that the following condions for a
return are fulfilled.
This warranty does not apply to any product damaged by accident, physical or electrical misuse or abuse, improper installaon, alteraon, any use
contrary to its intended funcon, war, fire, flood, or any other acts of nature, or unauthorized repair. This warranty does not apply to the LED driver
in the case of a hardwired product. This warranty does not apply to a product purchased from an authorized 3rd party dealer.
Koncept assumes no liability for any events such as fines arising out of the use of this product or any consequenal damages caused by any failure of
the product to funcon properly. In no event shall Koncept be liable for more than the replacement of the product. This warranty does not cover
shipping or labor costs associated with the replacement of a defecve product. Under no circumstances should this warranty or the product covered
by it be construed as an insurance policy against loss of any kind. Koncept staff neither assumes nor authorizes any person or organizaon to make
any warranes or assume any liability in connecon with the sale or use of this product.
This warranty covers only products used in the territory covered by your local distributor. This is the complete product warranty and no other
warranty exists. Some jurisdicons may not allow limitaons on how long an implied warranty lasts, or the exclusion or limitaon of incidental or
consequenal damages, so the above exclusions or limitaons may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary in different states and countries.
To file a replacement/repair claim under the warranty:
1) Contact Koncept for a return authorizaon number during the warranty period. A claim will not be accepted without a return authorizaon
number.
2) Provide a copy of the original purchase receipt with purchase date and product name clearly shown.
3) Return the defecve product to Koncept, freight prepaid, accompanied by (1) and (2) to the following address: Limited Product Warranty
Koncept Inc.
429 E. Hunngton Drive,
Monrovia, CA 91016
Limited Product Warranty
v.01092019
Boom view of canopy for 54” Z-Bar Pendant Rise Rectangle (Only one LED driver inside canopy of 38” Z-Bar Pendant Rise Rectangle)
If your canopy contains more than 1
LED driver, please connect all white
(neutral) wires together to Neutral
using a twist-on connector, and all
black (live) wires to Live using a
twist-on connector. Do not mix
neutral and live wires.