Installation & Assembly

KONCEPT
Assembly Instrucons
a. LED head
b. Body
c. Power supply
d. Hex key
e. Desk base
f. Splier cord*
g. Cord clips*
*applicable only when USB charging base opon is chosen. For other mounng opons, please refer to user manual for the mount.
Parts
e
f
f
d
b
c
a
f
g
g
1
b
a
2
Plug the body to the base
Push down to click into placePlug the LED head to the body
e
b
3
4a
*
5 6 7
c
b
e
Oponal USB Charging Base
Connect lamp cable and base cable to the
splier cord. Then connect the other end
of the splier cord to the power supply
cable. Plug in power supply to the wall
outlet. The USB port on the base charges
any smart devices.
Touch the center of the lens to change from
So (2700K) to Cool (5000K) light. Touch
and hold to cycle between two light colors
Built-in occupancy sensor shuts off the lamp
when moon is not detected for more than
15 minutes, and returns the lamp to its
original seng upon detecon of moon
A toggle switch on the back side of the lamp
head can be used to turn off the occupancy
sensor. The side with the magnifying wave
symbol signifies ON, the opposite side is OFF
Slide along the touchstrip to power
on/off and adjust brightness
4b
*
Pinch
Oponal USB Charging Base
Using the provided cord clips, bundle the
two cords together by pinching the cords
into the cord clips.
LED DESK LAMP
Secure the body to the base with the
hex key provided
e
b
d
Occupancy sensor
On
Occupancy sensor
switch
Off
Touchstrip
Brighter
Dimmer
Touch buon
USB port
mosso pro