Instructions / Assembly

1497 - Instructions ARCTIC CAT WILDCAT Roof - rev01 WWW.KOLPIN.COM
2
b) Install the roof to all clamps previously installed as shown below. Adjust the position of all components and tighten all hardware with
specified torque indicated below.
2. Maintenance and Care
Tighten all hardware after first use and periodically thereafter.
CLEANING:
 Rinse with lukewarm water; wash gently with mild soap or detergent and lukewarm water, using a soft cloth or sponge.
DO NOT SCRUB or use brushes or squeegees.
 Rinse again. Dry with soft cloth or moist cellulose sponge to prevent water spotting.
 To remove wet paint, glazing compound or grease, rub lightly with a good grade of VM&P naphtha or isopropyl alcohol,
then wash and rinse. DO NOT USE GASOLINE.
NOTICE: Abusive cleaning procedures by hand washing or automated washing equipment will eventually result in visual
hazing, loss of light transmission and coating delamination.
Compatible Cleaning Agents
 Aqueous Solution of Soaps and Detergents
- Fantastik1
- Joy2
- Neleco-Placer
- Hexcel, F.O. 554
- Windex5
- Formula 4091
- Lysol3
- Pine-Sol4
- Mr. Clean2
- Top Job2
IMPORTANT:
Torque
specification
Max. 5 foot-pounds
Applicable to all
Clamp screws
M6 x 20
(If torque tools are not
available, stop tightening
as soon as both male and
female clamp parts touch
as per picture beside.)
Philips truss screws
M6 x 20 (6x)
Plastic washer M6
(6x)