User's Manual
15
Calibration Instruction
Please follow below steps to calibrate the drone if the drone
becomes imbalance after crashing during the ight, and can
not be adjusted by trimmer button and cause dicult operation.
1. Power o the drone, then turn o the transmitter switch.
2. Turn on the transmitter switch, push the Left Stick all the
way down to the lowest position (Picture 6) and then
release. The Left Stick will back to the middle position
automatically (Picture 7). The transmitter is ready for
frequency pairing mode.
Picture 6 Picture 7
3. Power on the drone and put it on a at surface in a horizontal
position. The drone body lights change from ashing to
solid bright, which indicates successful frequency pairing.
4. Do not move the Left Stick before
successful calibration. Push the
Right Stick as Picture 8 shown and
then release. The drone body lights
ash, which indicates that the drone
is calibrating. When the drone body
lights become solid, which indicates successful calibration.
Notice: When the drone is ercely impacted or crashed, it may cause
the gyro can not recover and cause dicult control, if so, then
you need to power o and power on again to calibrate.
Picture 8
For technical support visti us at www.ykolibri.comFor technical support visit us at www.ykolibri.comFor technical support visit us at www.ykolibri.com