Installation Sheet

ManualsBrandsKoldfront ManualsAir ConditionersKoldfront 8000 BTU 115V Through the Wall Air Conditioner with 4200 BTU Heater with Remote and Sleeve

Preparations for Installation

NOTE: To avoid risk of injury and/or product/property damage,

please take the following precautions:

- Two or more people are needed to properly handle and install.

- Use proper lifting and carrying techniques.

- Before installation, ensure the wall and sill are able to handle

the weight and size of this unit.

- Wearing protective gloves will help to avoid injury from sharp

edges.

Before you begin, make sure you have all the parts necessary for

installation.

Name

Spec.

Qty

Tapered Spacer Blocks

17” Long

Centering/Support Blocks

4 ½” x 3 ½“ x 1 ½“

Plastic Divider

⅛ “x 4 ½“ x 14 ½“

Stuffer Seal

1” x 1 ½“ x 84”

Seal

1” x 1 ½” x 25”

Seal

1” x 1 ½“ x 14

Seal

1” x ⅜” x 25”

Seal

1” x ⅜” x 14”

Seal

1” x ¾” x 14”

Trim frame (side legs)

Trim Frame (top & bottom legs)

Ground Wire (green)

Toothed Washer for grounding screw

Grounding Screw

Grille (plastic)

Grille Aluminum

Nuts (plastic)

Screw Washer

Screw

Tools Needed:

Flat Screwdriver

Phillips Screwdriver

Tape Measure

Level

Drill

Summary of content (4 pages)

PAGE 1
Preparations for Installation Tools Needed: Flat Screwdriver Phillips Screwdriver Tape Measure Level Drill NOTE: To avoid risk of injury and/or product/property damage, please take the following precautions: - Two or more people are needed to properly handle and install. - Use proper lifting and carrying techniques. - Before installation, ensure the wall and sill are able to handle the weight and size of this unit. - Wearing protective gloves will help to avoid injury from sharp edges.
PAGE 2
Wall Sleeve Preparations Assembling the Koldfront Sleeve 1. Using the grounding screw and toothed washer, drill a 1/8” clearance hole (for the grounding screw) in a clear area about 3 inches back from the front edge of the sleeve through the left side. 2. Pull the loose end of the ground wire (green) out of the front of the sleeve. 3. Temporarily bend it down and around the lower edge of the sleeve. 4. This ground wire will later be attached to the frame of the Air Conditioner once it is installed.
PAGE 3
Installation Instructions Installing the Cabinet into the Wall Follow the steps listed below to install the cabinet into the wall 1. Remove existing rear grille as shown on Page 4 of this manual and replace with provided louvered rear panel. 2. Attach (1) 1”x ⅜” x 25” long seal in the center at the top of the sleeve. Remove the backing paper and press into position. 3. Attach (2) 1” x ⅜” x 14” seals to the left and right sides of the sleeve. 4.
PAGE 4
Direct Unit Mounting The previous directions are the preferable way to mount the new rear grill. The unit’s performance is slightly better and the possibility of draughts is reduced. As a last resort, direct mounting of the grille to the unit can be considered. NOTE: The grille must be installed prior to inserting the unit into the sleeve. Grille screw locations 1. Attach the (2) seal pieces (1” x ⅜” x 14”) as shown below. 2. Position the grille over the rear of the unit, making sure that: a.