Manualshelf

Installation Sheet

ManualsBrandsKoldfront ManualsAir ConditionersKoldfront 12,000 BTU 115V Portable Air Conditioner - Cools Medium Room Up To 400 Square Feet - with 10,000 BTU Heater and InvisiMist Drain Technology
11121314151617181920
14
Dehumidifying Mode
During the Dehumidifying mode, the unit will condense water out of the air and exhaust it through the
exhaust hose. The ambient temperature in the room will probably drop by a few degrees while using the
Dehumidifying mode. The front panel lights will be yellow.
To operate the unit in dehumidifying mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button on the remote control.
3. Press the Mode button until the dehumidify indicator is selected.
Heat Mode
This mode allows the unit to run as a heat pump. The unit must be vented for it to expel the cold air out
of the exhaust.
To operate the unit in heat mode:
1. Press the Mode button until the heat indicator is selected.
2. Set the thermostat by using the Up and Down buttons.
Fan Only Mode
Fan Only mode is used to circulate the air in your room. No temperature setting is needed. The front
panel lights will be green.
To operate the unit in Fan Only mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button on the remote control.
3. Press the Mode button until the Fan Only indicator is selected.
4. Press the Speed button to select the fan speed. You can choose between Automatic,
High, Medium, and Low.
Automatic Mode
In Automatic mode, the unit will cool, dehumidify, or heat (certain models) depending on the ambient
temperature. As the temperature in the room changes, the mode and fan speed will change
automatically. The front panel lights will change depending on the mode. You cannot select a specific
temperature in this mode. For more precise control, run the air conditioner in either Cool Mode or Heat
Mode (certain models).
To operate the unit in Automatic mode:
1. Make sure the power cord is plugged into a power outlet.
2. Press the Power button on the remote control.
3. Press the Mode button until the Automatic indicator is selected.
Notes: If the room temperature is below 77° F, the fan will always run on low speed in this mode. If you do
not use the exhaust hose in Dehumidify Mode, you must manually drain the water from the unit.
Note: Fan Only mode does not require that the exhaust hose be attached.