SDS

Theabovetest(s)is/areaccreditedunderthelaboratory’sISO/IEC17025accreditationissued bytheANSI‐
A
SQNationalAccreditationBoard (ANAB)
accordingtocertificateandscopeofaccreditation(Cert ificate#AT‐1500.)Test(s)markedwith‘#’is/arenotcoveredunderthescopeofaccreditation.
Thetestresult(s)andconclusion(s)inthisreportrelatetothesample(s)testedasdescr i bedherein.
Thistestreportmaynotbereproducedinwholeorinpart,withoutwrittenapprovalofANSECOGroup(HK)Limited.
ANABisreco
g
nizedb
y
ILAC
,
APLACandIAACasasi
g
nator
y
ofmultilateralreco
g
nitionarran
g
ementsthatfacilitateacce
p
tanceoftestinternationall
y
.



TESTREPORT
Company: Numo Manufacturing
Test Report #
16H-00122
Recipient: Rebecca Williams Date of Issue: January 14, 2016
Recipient Email: [e-mail] Pages: Page 4 of 12
cc to Email: - Date Received: January 11, 2016
ANSECO GROUP (HK) LIMITED 14/F, Yoo Hoo Tower, 38-42 Kwai Fung Crescent, Kwai Chung N.T., Hong Kong Tel: [phone] Fax: [phone]
ansecogroup.com
AT-1500
V
er.05CS-HK-RE005
DETAILED RESULTS:
CPSIA Section 108, Phthalates – Mouthable (DBP, BBP, DEHP, DnOP, DINP, DIDP)
Analysis performed by Gas Chromatography/Mass Spectrometry to determine compliance with the above
referenced regulation. [Referenced Test Method: CPSC-CH-C1001-09.3]
Specimen No. 1 2 3 4+5+6 7+8+9
Test Item
Result
(ppm)
Result
(ppm)
Result
(ppm)
Result
(ppm)
Result
(ppm)
Limit
(ppm)
DBP ND ND ND ND ND 1000
BBP ND ND ND ND ND 1000
DEHP ND ND ND ND ND 1000
DnOP ND ND ND ND ND 1000
DINP ND ND ND ND ND 1000
DIDP ND ND ND ND ND 1000
Conclusion PASS PASS PASS PASS PASS
Note:
DBP = Dibutyl phthalate; BBP = Benzyl butyl phthalate; DEHP = Di-(2-ethylhexyl) phthalate
DnOP = Di-n-octyl phthalate; DINP = Diisononyl phthalate; DIDP = Diisodecyl phthalate
ppm (Parts per million) = mg/kg (Milligrams per kilogram) = 0.0001 % w/w (Percent by weight)
LT = Less than
ND = Not detected (Reporting Limit = 120ppm)
Composite results are based on specimen of least mass resulting in highest potential concentration.