User Manual

Walk-in mainTenance

ELECTRICAL CONNECTION

Referring to the wiring diagram in the "Electrical Connections" section of this manual, connect the heater wire leads

as shown. If short lengths of the lead wires were left as indicators, connect the replacement heater leads to those

points of connection and discard the short indicator lengths.

NOTE: If one of the heater leads connects to another wire through a wire connector, obtain a properly sized, twist-

on wire connector for this purpose.

Replace the pilot light and switch in the switch box and attach the switch cover to complete the job. Energize the

walk-in cooler to resume operation.

POSITIONING THE

THERMOMETER

SENSING BULB

For convenient monitoring of the

temperature of the storage compartment

of this walk-in, a remote reading, solar

thermometer has been installed in the

door section at about eye level. It is a

flush panel mount with an LED readout.

For optimum accuracy, the sensing bulb

must be exposed to the air that is

being monitored. Make certain that the

sensing bulb is not positioned near the interior light or any other heat

producing device, nor should it be located where stored products

shield the sensing bulb from the circulating air pattern within the walk-

in. The long sensing lead is more than adequate to provide an ideal

sensing bulb placement on the inside surface of the door section or

an adjacent wall or corner panel. When the location is finalized, an

adhesive backed, plastic clip is used to secure the sensing bulb to that

surface.

PANEL CLEANING AND MAINTENANCE RECOMMENDATIONS

During the course of uncrating, handling and installation, the panel surfaces of your walk-in cooler or freezer may

have become stained or dirty. Cleaning all metal type surfaces, door trim and gaskets can be performed with a

mild detergent and hot water. It is important that you remove all excess soap and dry the surfaces

thoroughly. Never, under any circumstances, use an abrasive or alkaline solution.

Occasionally it may become necessary to clean the interior surface for sanitary purposes. A mild solution of baking

soda and warm water will tend to impart a clean, sweet smell to the interior should odors occur from spillage or

container breakage. Never leave standing water inside the walk-in cooler or freezer.