Specification Sheet

doors Feature a stepped
proFIle desIgn
sprIng actuated
door closer
Vapor prooF lIght FIxture
deadbolt locKIng handle
NL 9800 Deadbolt locking handle
with independent key/padlock
feature and inside safety release.
Floorless Models are
s
upplIed WIth a patented
VInyl Floor sealer
DOOR
Door sections manufactured at Nor-
Lake are factory tested to assure
proper t, performance and alignment.
All doors feature a stepped prole
design that serves as a barrier to air
ow which results in an energy efcient
door system.
Each Kold Locker™ walk-in
compartment is equipped with a 26”
wide door. The height of the door
opening varies with the series of
Kold Locker™ walk-in ordered. The
45 Series has a 59” high door, the
Standard Series (6’7” high) has a 66”
high door and the 74 and 77 Series
Kold Locker™ walk-ins have a 78” high
door. The door is self-closing, ush
mounted, intting and constructed to
incorporate heavy duty, molded ABS
breaker which is permanently foamed-
in-place.
Doors are available with right or left
side hinges and include two cam-lift
hinges, top hinge eld adjustable with
locking set screw, spring actuated
door closer, NL 9800 deadbolt locking
handle with independent key/padlock
feature and inside safety release. The
doors are pre-hung in a four foot wide
frame panel which is equipped with
replaceable perimeter heater wire,
magnetic stainless steel trim, digital
thermometer, vapor-proof light xture
and switch with exterior pilot indicator
light.
The door section is completely pre-
wired within concealed conduit inside
the door frame panel. 115/60/1
electrical is eld wired to a junction
box which is surface mounted on the
interior frame above the vapor proof
light xture.
Hinges and door handle are mounted
to 1/2” synthetic insulated tapping
plates. Each door section is complete
with a berglass reinforced plastic
heated threshold.
FLOOR CONSTRUCTION
Floor panels (when supplied) are
similar in construction to the wall
panels except they are made to
withstand uniformly distributed oor
loads of up to 800 pounds per square
foot. The interior oor metal is smooth
aluminum.
The 74 Series, oorless models, are
supplied with a patented vinyl oor
sealer to stop conductivity at oor
level. This unique sealer sits at on
existing oors and ts tightly against
the interior/exterior wall panels. The
walk-in wall panel is supported on the
shoulder of the sealer so the foam
edge is free of compressing weight.
The vinyl oor sealer is NSF listed.
dIgItal therMoMeter/
lIght sWItch