Product Manual
11. Insert the Hex Key into one Grub Screw at a time and turn it anti-clockwise
sufciently to release the round or square head adapter.
12. Fit either the 150mm, 100mm or both Extension Pieces over the Collar and tighten
the Grub Screws to secure it.
13. Fit the appropriate Head Adapter over the Extension Piece and tighten the Grub
Screws to secure it.
14. Repeat steps 8 and 9.
15. Place a vehicle support stand at an appropriate spot under the chassis of the
vehicle suitable for resting and securing the vehicle and then lower the vehicle by
gently turning the Release Valve on the Kojack anti-clockwise until the vehicle is resting
on the vehicle support stand.
16. Remove the Kojack
®
• Remove the round or square Head Adapter, Extension/s and Collar.
• Ensure the Cap and threaded section is secured in the Hydraulic Ram by turning
it clockwise until it will turn no more.
• Ensure the Hydraulic Ram is secure in the Kojack
®
by pushing it down as far
as it will go. (If you have not already opened the Release Valve you will need to
do this to lower the Hydraulic Ram)
• Store the Kojack
®
and its components upright in a dry environment to prevent
the components from rusting.
• Store the Kojack and its components in a safe place inaccessible to children.
OPERATING INSTRUCTIONS - TO LIFT CONTINUED
OPERATING INSTRUCTIONS - TO LOWER
AFTER USE AND STORAGEAFTER USE AND STORAGE
purpleline.com.au
Hydraulic Caravan & RV Jack
17. Position the Kojack
®
as per the set up used to raise the vehicle, under the round
socket or square mount on the vehicle.
18. Repeat Steps 8 and 9.
19. Remove the vehicle support stand.
20. Insert the Jack Handle into the Release Valve of the Kojack
®
and gently turn
anti-clockwise to lower the vehicle.
21. Remove the Kojack
®
.