Product Manual

5
39 590 01 Rev. C
KohlerPower.com
EN
Operation
WARNING
Rotating Parts can cause severe
injury.
Stay away while pump is in
operation.
Keep hands, feet, hair, and clothing away
from all moving parts to prevent injury. Never
operate pump with covers, shrouds, or
guards removed.
NOTE: If there is no fl ow of liquid through
pump, stop it and check suction circuit
(suction strainer (I), pipes and
inspection fl ap (W)).
NOTE: Avoid placing any fl ammable materials
near exhaust outlet during operation.
Do not place any material on pump
during operation.
Pump controls fl ow of liquid in accordance with
its running speed. Pump engine is equipped
with a speed control lever (Q) that enables fl ow
from pump to be controlled.
Flow from pump also depends on suction and
discharge elevation heads and on quality of
liquid that is being pumped (clean / muddy
water).
1. Loosen speed control lever (Q) wing nut.
2. Move position of speed control lever (Q)
(MAX to increase fl ow, MIN to reduce it).
3. Tighten speed control lever (Q) wing nut.
Angle of Operation
Do not operate this engine exceeding maximum
angle of operation; see specifi cation table.
Engine damage could result from insuffi cient
lubrication.
Stopping
1. Activate stop lever (S).
2. Pump stops.
3. Disconnect suction and discharge pipes and
allow liquid to fl ow out.
4. If pump is not used again on same day, rinse
it out.
Rinsing
After pump has stopped and cooled down.
1. Fill pump body with clean water via pump
discharge port (B) or through pump fi ller cap
(F).
2. Slowly pull on recoil starter handle (P)
several times until resistance is encountered
and then allow it to return gently.
3. Unscrew and remove pump drain plug (V)
from pump and allow water to fl ow out.
4. Screw pump drain plug (V) back into
position.
5. Repeat operation if necessary.
6. Open inspection fl ap (W), remove any dirt if
necessary and rinse thoroughly with clean
water.
7. Close inspection fl ap (W).
8. Clean suction strainer (I), remove any dirt if
necessary and rinse with clean water.
Engine Speed
NOTE: Do not tamper with governor setting to
increase maximum engine speed.
Overspeed is hazardous and will void
warranty.