Specifications

No change in measurements if connected with drain illustrated. (K-37386)
3"
(76 mm)
3-3/4"
(95 mm)
13-1/4"
(337 mm)
8"
(203 mm)
Recommended Faucet Hole Location
4"
(102 mm)
4"
(102 mm)
Recommended Faucet Location
60-11/16" (1541 mm)
4"
(102 mm)
26-1/2"
(673 mm)
46" (1168 mm)
30-5/16"
(770 mm)
1/4"
(6 mm)
12-1/4"
(311 mm)
Lumbar
Angle 20°
3-1/8"
(79 mm)
18-3/16"
(462 mm)
5-3/4"
(146 mm)
34-11/16" (881 mm)
18-5/16"
(465 mm)
25-5/8"
(651 mm)
Notes
Required Electrical Service
Measure your actual product for rough-in details.
One circuit required, protected with Class A Ground-Fault
Circuit-Interrupter (GFCI). Outside North America, this device may
be known as a Residual Current Device (RCD).
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
120 V, 15 A, 60 HzHeated Surface:
Technical Information
All product dimensions are nominal.
If installing a rim-mount faucet, make sure there
is no interference above or below the deck before
drilling any holes.
FreestandingInstallation:
CenterDrain location:
39-5/8" x 23-5/8" (1006 mm x 599 mm)Basin area, bottom:
49-9/16" x 25-1/2" (1259 mm x 648 mm)Basin area, top:
170 lbs (77.1 kg)Weight:
49.8 lbs/ft² (243.1 kg/m²)Minimum floor load:
16" (406 mm)Water depth:
60 gal (227.1 L)Water capacity:
Footprint, 1364288, not required, not
included
Template:
Heated Surface: 120 V, 0.5 A, 50/60 Hz,
65 W
Electrical component
rating:
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
3-6-2020 06:23 - US/CA
Sunstruck
®
Freestanding Bath
K-24002-W1