Dimensions and Measurements

Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
45-1/8″ (114.6 cm) x 19-11/16″
(50 cm)
Basin area, top 52-3/4″ (134 cm) x 25-5/16″ (64.3 cm)
Weight 84 lbs (38.1 kg)
To overflow:
Water depth 15″ (38.1 cm)
Capacity 58 gal (219.5 L)
* Approximate measurements for comparison only.
Drop-in cutout 58-1/2″ (148.6 cm) x 30-1/2″ (77.5 cm)
Blower
motor:
Heater V Hz A
300 W 120 60 5
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor: 120 V, 15 A, 60 Hz
Blower motor is supplied with a 24″ (61 cm)
grounding-type plug-in cord.
Installation Notes
Install this product according to the installation guide.
Floor support under this product must provide for a minimum
of 45 lbs/square foot (218 kg/square meter) loading.
The hot water supply should be 70% of the capacity of the
bath or greater. Installations will vary.
A blower motor access panel is required.
This product is designed for a drop-in installation only. It is not
suited for use in a three-wall alcove with an overhead shower.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
32" (81.3 cm)
60" (152.4 cm)
1-1/2"
Bath Drain
3/4" (1.9 cm)
No change in measurements if connected
with drain illustrated. (K-7272)
Drop-In Rim
Detail
1-1/2"
(3.8 cm)
19"
(48.3 cm)
11-1/4"
(28.6 cm)
16"
(40.6 cm)
2-1/2"
(6.4 cm)
Blower Motor Access
20" (50.8 cm) W x
15" (38.1 cm) H
1-1/4"
(3.2 cm)
4-1/8"
(10.5 cm)
Product Diagram
ARCHERTM
ARCHERTM 5’ (1.5 m) BUBBLEMASSAGETM BATH WITH AIRJETS
Page2of2
1071360-4-
E