Specification

Required Accessories
K-11748-KS Rite-Temp valve with diverter and stops ❑ NA
* For a complete listing of all the Rite-Temp valves, refer to the K-304-* Specification Sheet or Roughing-In Sheet.
Optional Accessories
88526 HiFlow Rite-Temp
®
thin wall installation kit ❑ CP ❑ Other ____
Installation Notes
Install this product according to the installation guide.
NOTICE: Risk of product damage. Long screws, for
installing trim, can damage the K-2971-KS valve. Consult the
trim installation guide to verify if the thin wall installation kit
(88526) is needed.
Avoid cross-flow conditions. Do not install shut-off device on
either valve outlet.
Cap shower outlet if deck-mount spout, diverter, or
handshower is connected to spout outlet.
Install straight pipe or tube drop of 7″ (17.8 cm) to 18″
(45.7 cm) with single elbow between the valve and wall-mount
spout.
10" (25.4 cm)
to Spout
(Bath Only)
2-1/8"
(5.4 cm)
10-5/16"
(26.2 cm)
3-9/16"
(9 cm)
7-3/16"
(18.3 cm)
For 1/2" NPT spout, pipe must
extend 7/16" (1.1 cm) beyond
finished wall.
3-3/16"
(8.1 cm)
5-1/2"
(14 cm)
48" (121.9 cm)
to Floor
(Shower Only)
72" (182.9 cm)
78" (198.1 cm)
to Floor (Typical)
6-1/2"
(16.5 cm)
6-1/2"
(16.5 cm)
4"
(10.2 cm)
1/2" NPT
6-13/16" (17.3 cm)
Top of Bath
Product Diagram
MARGAUX
®
RITE-TEMP
®
MARGAUX
®
RITE-TEMP
®
BATH AND SHOWER TRIM
Page2of2
1059598-4-
D