Specification

1/2" NPT pipe nipple must
extend 1-1/8" (29 mm)
beyond finished wall.
5" (127 mm)
3"
(76 mm)
Ø 6-1/2"
(165 mm)
8" (203 mm)
8-7/16" (214 mm)
2-1/8"
(54 mm)
Ø 4"
(102 mm)
Ø 4"
(102 mm)
Threaded Spout:
Extend 1/2"-14 NPT pipe 1-1/8"
(29 mm) from finished wall.
Notes
Technical Information
Install this product according to the installation
instructions.
All product dimensions are nominal.
Avoid cross-flow conditions. Do not install shut-off
device on either valve outlet.
Cap the shower outlet if deck-mount spout,
diverter, or handshower is connected to the spout
outlet.
Install straight pipe or tube drop of 7" (178 mm)
to 18" (457 mm) with single elbow between the
valve and wall-mount spout.
ADA, OBC, CSA B651 compliant when installed
to the specific requirements of these regulations.
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
9-28-2018 16:48
Purist
®
Rite-Temp
®
Bath/Shower Valve Trim with Diverter
K-T14420-4L