Specification

Installation Notes
Install the valve trim according to the installation guide.
Install the Rite-Temp valve according to the installation guide.
Avoid cross-flow conditions. Do not install a shut-off device on
either valve outlet.
Cap the shower outlet if the deck-mounted spout, diverter, or
handshower is connected to the spout outlet.
Install a 7″ (178 mm) to 18″ (457 mm) straight pipe or straight
tube with single bath elbow between the valve and the
wall-mount spout.
Top of Rim
6-1/2" (165 mm)
4-1/8"
(105 mm)
6" (152 mm) Thick Wall
6-3/4" (171 mm) Thin Wall
1/2" NPT
1/2" Hot
1/2" Cold
10" (254 mm)
to Spout
(Bath Only)
Ø 6-7/16"
(164 mm)
2-3/4" (70 mm) Thin Wall
3-1/2" (89 mm) Thick Wall
If over 3-1/2" (89 mm) and
up to 4-1/4" (108 mm),
use Deep Roughing-in kit.
For slip-fit spout, 5/8" OD tube
must extend 5" (127 mm) beyond
finished wall.
For 1/2" NPT threaded spout, pipe
must extend 5" (127 mm)
beyond finished wall.
72" (1829 mm) -
78" (1981 mm)
to floor (Typical)
48" (1219 mm)
to floor
(Shower Only)
Ø 2" (51 mm) Max
Hole in the Wall.
Supply tube must
be centered in the
hole.
4" (102 mm)
Product Diagram
MISTOSTM
MISTOSTM BATH & SHOWER TRIM SET
Page2of2
1171693-4-
B