Installation Sheet

10. Adjust Panel (Some Models)
CAUTION: Risk of property damage. Pivoting panels that are misaligned or set too close to the
main mirror can chip or break. If needed, make adjustments to properly align the panels with the
main mirror. The recommended gap between the panels is 3/16″ (5 mm).
NOTICE: Alignment of the pivoting panels has been set at the factory. Do not make adjustments
unless you have replaced the panels.
Fold the pivoting panel against the main mirror.
Loosen the lock screws on the top and bottom hinge approximately 1/4 turn clockwise.
Tight Gap Adjustment: Turn the jack screws counterclockwise in 1/4 turn increments at the top
and bottom of the mirror.
Tilt Adjustment: Turn the jack screw counterclockwise in 1/4 turn increments at the top or bottom
of the mirror, whichever has the tighter gap.
Height Adjustment: Turn the screw at the bottom of the mirror to raise or lower the pivoting panel
to the same height as the main mirror.
Slowly unfold the panel and check alignment.
Repeat the adjustments as needed.
Once all adjustments are complete, tighten the lock screws on the top and bottom hinge.
Gap
Tilt
Height
Adjust the
tighter gap.
Jack Screws
Lock
Screws
1337910-2-B 14 Kohler Co.