Specification

Technical Information
Fixture*:
Bathing well:
Basin area,
bottom
40-1/2″ (1029 mm) x 20″ (508 mm)
Basin area, top 52-3/4″ (134 mm) x 24″ (610 mm)
Weight 290 lbs (131.5 kg)
To overflow:
Water depth 13-5/8″ (346 mm)
Capacity 60 gal (227.1 L)
* Approximate measurements for comparison only.
Drop-in cut-out 58-1/2″ (1486 mm) x 30-1/2″ (775 mm)
Cut-out for
undermount
K-586
Blower
motor:
Heater V Hz A
300 W 220-240 50/60 3
Required Electrical Service
Dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI):
Blower motor/control 220-240 V, 15 A, 50/60 Hz
Installation Notes
Install this product according to the installation guide.
NOTICE: If the blower motor and check valve are
relocated, two access panels are required. Locate one
access panel at the blower motor/control location and the
other at the control box. Locate the blower motor and check
valve together.
Will comply with ADA when installed per Section 607
Bathtubs of the Act.
Floor support under bath must provide for a minimum of 60
lbs/square foot (290 kg/square meter) loading.
Splitting the deck/surround is recommended if installing into a
deck.
Hot water supply should be 70% of capacity or greater.
Installations will vary.
No change in measurements if connected with
drain illustrated. (K-7169-AF)
Blower Motor/Control Access
34" (864 mm) W x
15" (381 mm) H
1-1/2" OD
2-7/8"
(73 mm)
3" (76 mm)
3/4"
(19 mm)
60" (1524 mm)
32" (813 mm)
16"
(406 mm)
2-1/2"
(64 mm)
18-1/4"
(464 mm)
14" (356 mm)
1-5/8"
(41 mm)
2-1/2"
(64 mm)
NOTE: Blower protrusion beyond the rim.
1/4" (6 mm)
Product Diagram
TEA-FOR-TWO
®
TEA-FOR-TWO
®
5’ (1.5 m) BUBBLEMASSAGETM BATH
Page2of2
1146819-4-
B