Installation Sheet

3. Install the Cabinet
3/32"
2" (51 mm)
2" (51 mm)
NOTE: Cabinet orientation with door swing to the right is shown.
Verify the door swings in the direction that was determined in the “Roughing-In” section. If not, rotate the cabinet 180
degrees.
Lift the cabinet onto the hanger. Make sure that the cabinet hooks and engages the hanger.
Feed the wires through the hole in the back of the cabinet.
Center the cabinet on the wall as desired.
Position each retaining clip 2" (51 mm) from the sides of the cabinet on both the top and boom of the cabinet.
Using a 3/32" drill bit, drill pilot holes into the wall.
If anchors are needed, remove the cabinet and install anchors into the wall at the pilot hole locations.
Secure the retaining clips with the 1-1/2" screws (provided).
Kohler Co. 7
1470425-2-A