Installation Sheet

2. Install the Hanger
3/16"
1"
(25 mm)
3/32"
Using a 3/16" drill bit, drill three holes on the groove of the hanger, with at least one of the holes where the stud
location is marked.
Position the hanger on the wall, with at least one hole at a stud location.
Verify that the hanger is level and then mark the hole locations on the wall.
Drill 3/32" pilot holes at the marked locations where there is a wall stud.
Drill holes at the other marked locations for anchors and then insert the anchors (not provided).
Secure the hanger with three screws (provided).
1470425-2-A
6 Kohler Co.