Installation Sheet
1. Prepare the Site
20"
(508 mm)
Ø 3/4" (19 mm)
WARNING: Risk of electric shock. Disconnect the power before performing the following procedures.
WARNING: Risk of electric shock. A qualied electrician should route all electrical wiring.
IMPORTANT! This cabinet is for surface-mount installation only.
NOTE: Cabinet orientation with door swing to the right is shown.
Mark the hanger position and stud locations on the wall.
Mark the stud locations on the hanger.
Determine the electrical wire hole location according to the dimensions shown in the "Roughing-In" section.
Drill a 3/4" (19 mm) hole in the wall for the electrical wires.
Route the electrical supply wires through the hole in the nished wall.
Each wire should extend at least 20" (508 mm) from the hole.
Kohler Co. 5
1470425-2-A