Installation Sheet
Roughing-In
3" (76 mm) Min
3" (76 mm)
5-1/2"
(127 mm)
2-7/16" (62 mm)
Hole in wall for
left door swing.
Left Door Swing
Right Door Swing
Electrical wires
enter here.
Hole in wall for
right door swing.
Electrical wires
enter here.
NOTICE: The cabinet is designed for either right or left door swing. To change the orientation, rotate the entire cabinet
180 degrees.
Determine whether the door will swing open to the right or left.
When determining the height of the product, verify that the doors will clear all obstacles (such as a faucet or light xture).
A minimum distance of 3" (76 mm) is required.
Plan for the location of the wall-mounted dimmer or light switch and GFCI* protected circuit.
The electrical wires should enter the cabinet 5-1/2" (127 mm) from the boom and 2-7/16" (62 mm) from the side where the
door hinges are located.
If the door swings to the right, the electrical wires will route through the nished wall and enter the cabinet on the right
side. If the door swings to the left, the electrical wires will route through the nished wall and enter the cabinet on the left
side.
*Outside North America, this may be known as a Residual Current Device (RCD).
1470425-2-A
4 Kohler Co.