Installation Sheet

6. Install the Junction Box
LED Power Cable
Junction Box
Bracket
Junction Box
SlotTab
Cap
LED Power
Connector
LED Power
Cable
WARNING: Risk of electric shock. Disconnect the pow
er before performing the following procedures.
CAUTION: Risk of product damage. Do not force the plug on the end of the LED power cable into the LED power
connector inside the cabinet. Align the slot on the LED power cable with the alignment tab on the LED power
connector.
NOTE: Cabinet orientation with door swing to the right is shown.
Unthread and remove the protective cap from the lower LED power connector located inside the cabinet where the
junction box will be installed.
Plug the LED power cable into the LED power connector.
Position the junction box into the cabinet. Make sure that the top of the junction box clips over each bracket.
Secure the junction box with the two screws (provided).
1470425-2-A
10 Kohler Co.