Installation Sheet
3. Position the Threshold
NOTICE: The threshold must sit on a flat surface.
If needed, file the ends of the threshold to match the corner radius of the shower wall.
Align the threshold so that it is 1/8″ (3 mm) from the shower base/bath ledge along its entire
length and mark its location.
Apply 100% silicone sealant to the groove in the bottom of the threshold.
Tape the threshold securely in place along the mark, centered between the walls.
Groove
1/8"
(3 mm)
1/8"
(3 mm)
1381418-2-B 6 Kohler Co.