Installation Sheet

Troubleshooting (cont.)
Troubleshooting Table
Symptoms Probable Cause Recommended Action
C. Water leaks under a door panel. C. Remove wall jamb covers and
make sure that cleats are installed
correctly. If there is a gap between
the wall jamb and the cleat, the
door panels could be installed too
high.
D. Water leaks between door
panels.
D. When showering, make sure that
the inside panel is closest to the
showerhead.
E. Water leaks between a door
panel and a wall jamb.
E. Adjust the rollers so that the
bumpers contact the wall and the
door panel evenly. See the ″Adjust
the Rollers″ section.
F. Water leaks between a door
panel and a wall jamb.
F. Order and install the optional seal
kit.
G. Water leaks behind wall jamb. G. Apply 100% silicone sealant to the
outside and inside edges of the
wall jamb. See silicone sealant
manufacturer’s instructions before
using shower.
6. Handle is not securely
installed.
A. Door panel not properly cleaned
before handle installed or
handle not pressed down firmly
during installation.
A. Clean door panel and install new
handle.
Kohler Co. 31 1381418-2-B