Installation Sheet

18. Assemble the Inside Panel
NOTICE: The inside panel roller mounting holes are 4-3/8″ (111 mm) below the top of the panel.
NOTICE: The inside rollers contain a brass insert.
Position each roller on the same side of the panel as the label.
Install each inside roller with the tab on top. This will position the door at its highest setting,
allowing for easier adjustment if necessary.
Secure each roller with a #10-24 x 1-1/4″ screw.
Using a hand screwdriver only, securely tighten the screws.
#10-24 x 1-1/4"
Tab Up
Clamp
Inside Roller
Brass Insert
4-3/8"
(111 mm)
Kohler Co. 21 1381418-2-B